Soundbar Will they put manual parametric equalization on their most powerful sound bars?

[hemiutut]

Hello:
Will you ever make manual parametric EQ available on the LCR and LFE channels?
8-10 filters per channel would be sufficient.
Implementing this option isn't very complicated and would give your sound bars a huge boost.

Written with a translator

Greetings from Spain

 

[Leongino]

Hello:
Will you ever make manual parametric EQ available on the LCR and LFE channels?
8-10 filters per channel would be sufficient.
Implementing this option isn't very complicated and would give your sound bars a huge boost.

Written with a translator

Greetings from Spain

Hi @hemiutut

A PEQ would be a great option because it allows very precise adjustments on each channel, helping to correct resonances and adapt the sound to the room. The only challenge is that it requires some knowledge to use properly, and in many cases even a measurement microphone to get the best results. Still, having 8–10 filters per channel would offer a much higher level of customization compared to the basic EQs usually found in soundbars.

They’re all good ideas.

 

[hemiutut]

Hi @hemiutut

A PEQ would be a great option because it allows very precise adjustments on each channel, helping to correct resonances and adapt the sound to the room. The only challenge is that it requires some knowledge to use properly, and in many cases even a measurement microphone to get the best results. Still, having 8–10 filters per channel would offer a much higher level of customization compared to the basic EQs usually found in soundbars.

They’re all good ideas.

When they implement this option in the ULTIMEA sound bars, they'll have a potential customer in me.
I can take measurements with the REW EQ Wizard + Umik-1 calibrated microphone and apply the necessary equalization.

Written with a translator

Regards