Soundbar ULTIMEA Quick Guide (5.1/7.1) — X40 & D80 Boom

Leongino

Administrator
Simple calibration — exactly how it worked for me..

Hi everyone 👋


Sharing a quick guide to dial in the Skywave X40 (5.1) and Poseidon D80 Boom (7.1) in just a few minutes.



Guide 1 — 10 minutes (the essentials)
  • Use HDMI eARC/ARC and set your TV to Bitstream/Passthrough/Auto (avoid PCM stereo).
  • Soundbar centered under the TV; sub on one side, 10–30 cm away from walls/corners.
  • X40 (5.1): Surround L/R at 110–120°, slightly behind the couch, ear height.
  • D80 (7.1): Side surrounds at 100–110° + Back at 145–160° behind (slightly softer than sides).
  • Starting point: Center +1 · Surround 0/+1 · Bass 0 · Treble 0.
  • Quick check: if voices are weak, raise Center; if bass booms, reduce Bass/Sub –1/–2.

Guide 2 — Fine-tuning (balance without independent BACK control)
  • Center +1/+3: aim to understand whispers without raising master volume.
  • Surround (global) 0/+2: on D80, favor Back via placement (closer and aimed at you); set side surrounds slightly off-axis.
  • Distances: keep symmetry; place Back 10–20% closer than side surrounds (≈ +2 dB perceived).
  • Sub: quick sub-crawl (move 20–40 cm) and pick the tightest bass; try phase 0/180°.
  • Lip-sync: adjust Delay in +10 ms steps if A/V feels off.
  • Night/DRC mode: handy for late viewing (fewer peaks and less bass).
Guide 3 — Ready-made profiles (save and switch)

Cinema/Series

  • X40: Center +1 · Surround +2 · Bass 0/+1 · Treble 0
  • D80: Center +1 · Surround +2 (global) · Back favored by placement · Bass 0/+1

Clear Dialogue
  • X40: Center +2/+3 · Surround –1/0 · Bass –1 · Treble +1
  • D80: Center +2/+3 · Surround –1/0 (global) · Bass –1 · Treble +1
Music/Gaming
  • X40: Center 0 · Surround 0/+1 · Bass 0 · Treble 0
  • D80: Center 0 · Surround 0/+1 (global) · Back 0 (via placement) · Bass 0

Quick checklist

⛔ Stereo only → set TV to Bitstream/Passthrough/Auto (not PCM).
⛔ Boomy bass → pull the sub 10–30 cm from walls and reduce Bass –1/–2.
⛔ Rears too quiet → X40: move surrounds slightly behind and set Surround +1/+2. D80: bring Back closer & aim at you; increase side surround angle.
⛔ Odd power-on volume → disable startup sounds and check HDMI-CEC.

This is what has worked for me in both systems.

🎬🍿🤗
 
This calibration guide is a true treasure! 🌟 We offer our sincerest gratitude. You've condensed professional acoustic tuning expertise into a clear, accessible, and highly practical guide, which will undoubtedly illuminate the path to superior listening for countless community members.

Best regards,
The Ultimea Team
 
Last edited:
Back
Top